주요 콘텐츠로 건너뛰기

Sony Clie PEG-NR70 Speaker Replacement

필요한 것

  1. Sony Clie PEG-NR70 Speaker Replacement, The Case: 1 단계, 이미지 1개 중 1개
    • Unscrew the 1.9mm screw located at the top of the device with a Phillips #00 screwdriver.

    • It may be helpful to set up a piece of paper to keep track of where removed screws came from.

  2. Sony Clie PEG-NR70 Speaker Replacement: 2 단계, 이미지 1개 중 1개
    • Unscrew the 2.5mm screw located on the left side of the device with a Phillips #00 screwdriver.

  3. Sony Clie PEG-NR70 Speaker Replacement: 3 단계, 이미지 2개 중 1개 Sony Clie PEG-NR70 Speaker Replacement: 3 단계, 이미지 2개 중 2개
    • Unscrew the five 2.5mm screws on the back panel with a Phillips #00 screwdriver.

    • Remove the back panel by lifting it away with your hands.

  4. Sony Clie PEG-NR70 Speaker Replacement, Speaker Rail: 4 단계, 이미지 2개 중 1개 Sony Clie PEG-NR70 Speaker Replacement, Speaker Rail: 4 단계, 이미지 2개 중 2개
    이 단계에 사용된 도구:
    Precision Tweezers
    €4.95
    • Use tweezers to unplug the speaker wire from the motherboard by pulling the plug (not the wires) down towards the speaker.

    • Be careful not to tear the speaker wires! They are very thin.

    • Remove the tape holding speaker wire by peeling it away.

  5. Sony Clie PEG-NR70 Speaker Replacement: 5 단계, 이미지 1개 중 1개
    • Holding down the speaker rail unscrew the two 2.5mm screws with a Phillips #00 screwdriver.

    • Remove the speaker rail vertically from the device.

  6. Sony Clie PEG-NR70 Speaker Replacement, Speaker: 6 단계, 이미지 1개 중 1개
    • Hold back the plastic tabs to pop the speaker out of the rail.

결론

To reassemble your device, follow these instructions in reverse order.

작성자

2다른 기여자 명과 함께

Daniel Soski

회원 가입일: 04/18/13

63 평판

안내서 6개를 작성함

Cal Poly, Team 14-11, Maness Spring 2013 Cal Poly, Team 14-11, Maness Spring 2013 회원

CPSU-MANESS-S13S14G11

5 회원들

안내서 8개를 작성함

0가이드 댓글

댓글 쓰기

조회 통계:

지난 24시간: 0

지난 7일: 1

지난 30일: 4

전체 시간: 376