Xbox Series X Back Panel Replacement

소개

Use this guide to remove or replace the back panel on an Xbox Series X.

Before you begin, completely power down and unplug all cables from your console. Remember to follow general electrostatic discharge (ESD) safety procedures while repairing your console.

필요한 것

1 단계 Uncover the back panel screws

Xbox Series X Back Panel Replacement, Uncover the back panel screws: 1 단계, 이미지 2개 중 1개

Xbox Series X Back Panel Replacement, Uncover the back panel screws: 1 단계, 이미지 2개 중 2개

Before you begin, completely power down and unplug all cables from your console.
Use a pair of tweezers to remove the sticker hiding the first screw on the back panel, near the base.

번역하기

2 단계

Xbox Series X Back Panel Replacement: 2 단계, 이미지 3개 중 3개

For cleaner removal, use an iOpener or hair dryer to heat the sticker.
Use a pair of blunt tweezers to peel back the large sticker on the back panel to reveal the second screw.
You only need to peel this sticker to where you can access the hidden screw. You don't need to pull it completely off.
Technically, these are tamper-evident stickers, but don't worry—Microsoft can't legally void your warranty, as long as you don't damage anything. Have fun!

번역하기

3 단계 Remove the back panel screws

Xbox Series X Back Panel Replacement, Remove the back panel screws: 3 단계, 이미지 1개 중 1개

이 단계에 사용된 도구:

Magnetic Project Mat

€19.95

구매

Use a T8 Torx driver to remove the two 7.4 mm‑long screws securing the back panel.
Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your console.

번역하기

4 단계 Unclip the back panel

Xbox Series X Back Panel Replacement, Unclip the back panel: 4 단계, 이미지 3개 중 1개

Xbox Series X Back Panel Replacement, Unclip the back panel: 4 단계, 이미지 3개 중 2개

Xbox Series X Back Panel Replacement, Unclip the back panel: 4 단계, 이미지 3개 중 3개

Insert the flat end of a spudger into the gap between the back panel and the shell, near the left side of the base.
Pry up the back panel to release it from the locking clips.

번역하기

5 단계

Insert the flat end of a spudger into the gap between the back panel and the shell, near the right side of the base.
Pry up the back panel to release it from the locking clips.

번역하기

6 단계 Remove the back panel

Xbox Series X Back Panel Replacement, Remove the back panel: 6 단계, 이미지 3개 중 1개

Xbox Series X Back Panel Replacement, Remove the back panel: 6 단계, 이미지 3개 중 2개

Xbox Series X Back Panel Replacement, Remove the back panel: 6 단계, 이미지 3개 중 3개

Grip the back panel at the opening you just created and pull it up and away from the shell to unclip the long edges.
During reassembly, press along the edges of the back panel to snap it into place.

번역하기

7 단계

Xbox Series X Back Panel Replacement: 7 단계, 이미지 3개 중 3개

The back panel slots into a gap at the top of the shell.
Tilt the back panel up and pull it away from the top edge of the shell to release it from the gap.
Remove the back panel.